鼓式制动器检修（Drum brake repair）.doc

鼓式制动器检修（Drum brake repair） The following is the relevant content of drum brake overhaul and engine underpowered problems. Please be sure to master it carefully, and master the four points: 1. Tools, gauges and equipment used in the repair process of drum brakes? 2. How to check the drum brake correctly? 3. How to repair drum brake correctly? 4. What are the main reasons for the lack of engine power? How to exclude? One, rear axle drum brake maintenance 0 (1) decomposition: (1) half - axis, locking nut, lock washer, oil seal, hub adjusting nut, outer bearing, wheel hub brake drum, inner bearing (2) return spring, locking plate (or opening pin), brake shoe (ii) maintenance: 1. Brake drum (1) can be used on method, direct method, such as dynamic inspection has crack, drum lining work shall be no significant grooves, such as pull groove depth is greater than 0.50 mm of brake drum face when boring processing and repair. (2) with special frame of the dial indicator or bow inner dial indicator check the abrasion of working face, when the roundness is greater than 0.25 mm, and the alignment error exceeds 0.50, dealing with the brake drum face boring processing and repair. (3) after boring, the geometric shape relative position and surface roughness of the working surface of the brake drum should meet the requirements. The inner diameter of the two brake drums on the same axis should be less than 1mm. The inner diameter of the brake drum cant exceed the regulation value after boring and repairing (east windmill is not more than 6mm). (4) check the hub bearing and the bearing hole to maintain the cooperation, and must not loosen. 2. Brake shoes (1) check the brake shoes and friction pieces should be free of cracks, the surface should be free of serious ablation, the rivets should not be loose, the rivets should not be less than 0.5mm, or they should be replaced. (2) the friction plate requires solid and reliable riveting, new friction plate or boring brake drum, which shall b