物化实验答案（Objectify experimental answers）.docVIP

物化实验答案（Objectify experimental answers） 1. The combustion heat measured at constant volume is called constant volume combustion heat (QV), and the relationship between the combustion heat under constant pressure condition is called constant pressure combustion heat (Qp). nRT It is. 2. The conductance measurement solution, because the ions on the electrode discharge, will produce polarization, so usually communicate with higher frequency of __ _____ _____ _____ a bridge to measure the electrodes are used by _________ platinum plated black ___ to reduce polarization effect. 3. The main function of the auxiliary electrode (electrode) in electrochemical tri-electrode system is to form an electric current loop with the working electrode. 4. The measurement system of two component metal phase diagrams should be as close to the equilibrium state as possible, so the temperature should not be reduced when cooling is required (fill or slow). 5. The reason of the conductivity of KCl solution is to determine the ionization constant of acetic acid Any conductivity meter system error, and lead to measure conductivity value deviates from the value of the samples actual conductivity, so it need standard of KCl solution to determine the value of the measured conductivity, with standard conductivity value for a working curve, to eliminate the systematic error of the instrument. . 6. In a completely mutually soluble non-ideal two-fluid system, the solution has the lowest (the highest or lowest) constant boiling point if there is a positive deviation in raoults law. The constant boil is a mixture (compound/mixture). 7. In the test of saturated vapor pressure of water, the gram - gram equation is used, and its basic hypothesis is: (1)? VapHm is constant in the range of experimental temperature; (2) Vm (g) -vm (l) (g) (3) the gas phase is an ideal gas; 1. Why is the temperature of the water temperature in the inner tube lower than the external cylinder? How much lower? Why is that? The am