安全防护设施方案（Safety protection scheme）.doc

安全防护设施方案（Safety protection scheme） Safety protection scheme 1. Project overview: 1.1 project overview: 1) project name: 2) engineering address: 3) construction unit: 4) design unit: 5) supervision unit: 6) construction unit: 7) structure type and building number: 8) construction area and height: 1.2 dangerous position: The dangerous parts of the project that require safety protection are shown in the table below: Project risk location The serial number Risk categories Room number, floor and site 1 Floor opening 2 The stairs 3 The elevator well 4 Balcony, floor edge 5 Derrick, elevator feeding port 6 Derrick, elevator connection 7 Construction pass 8 Deep hole edge 2. Safety protection design 2.1 floor reserve hole protection 2.1.1 side length or diameter shall be reserved for the opening of the floor with 150mm ~ 1400mm. Protective cover plate using a standard hinge flip: make connection with L36 x 3 Angle iron, Angle of a limb punched by expansion bolt is fixed on the hole edge of the floor slab, another limb Angle steel welded connection above the hinge of a page, the hinge is another page using wood screw with wooden cover plate connection, become can turn 90 ° upward hole cover plate. The production requirements of the hole cover plate are shown in figure 1: the floor is reserved for the hole cover. 2.1.2 reserve side length or diameter at 1500 mm and above the mouth of the cave, security fence, shall be set up near the mouth of the fence by poling set-up as framework, and rail fastener bar consists of two way, on the rail epithelium and the floor of the distance is not less than 1200 mm, fence profile (with one side of the bar with federated eye network closed. Please see attached figure 2: safety protection of the edge of the hole 2.2 protection of stairs 2.2.1 the main protection part of the stairs is the temporary guardrail on the edge of the ladder and the top stair platform. Using steel pipe fastener to set up the stair temporary guardrail (guardrail heigh