安规试题（Safety tests）.doc

安规试题（Safety tests） 1. Fill in the blanks: (1.5 points per blank, 30 points) 1. The equipment is divided into two types: high voltage and low voltage: the voltage of the device to the earth is high and the voltage of the device is high, and the voltage of the device is low to 1000V and below. 2. In case of any doubt in operation, the operation should be stopped immediately and reported to the duty dispatcher or the duty officer, and then the operation shall be carried out after knowing the problem. Do not change the operation ticket without authorization, and do not remove the locking device at will. 3. One of the two working tickets must always be kept in the work place, received by the person in charge of the work, and the other shall be received by the job licensor and shall be transferred by value. 4. After all the work, the work class should be cleaned and organized. Working controller should be carefully check, after being evacuated all the staff work, to the personnel on duty clear repaired project, found the problem, test results and existing problems, etc., and check the equipment status, with the attendant presence of legacy objects, cleanliness, etc., and then fill in the working ticket Ming work end time, after examined and signed by both parties, working ticket party came to an end. 5. When the electrical equipment catches fire, the power supply of the equipment should be cut off immediately and then the fire can be saved. Should use dry fire extinguishers, carbon dioxide fire extinguishers and other fire extinguishers for electric equipment, not to use foam fire extinguishers. 6. Wells, pits, holes or channels in and outside the production plant must be covered with a solid flat plate with the floor flush. If you need to remove the cover in the repair work, you shall set up a temporary fence, temporary punch hole, hole, and after the construction is finished, you must restore the original form. 7. All lift ports, large holes, hole staircases and platfor