主板维修（Motherboard maintenance）.docVIP

主板维修（Motherboard maintenance） 1. Maintenance without electricity 1. South bridge (power supply) 2. I/O (power supply) 3. Gate circuit (VCC) 4. XY (voltage on both ends) 5. COMS battery 6. Jump (jumper cap) 2.5 v-3.3 V 7. Power - on unrated triode 5V 8, 5 VSB 9, the power - on No reset maintenance 1. The power supply of the clock chip is 3.3-2.5 V, and the surrounding inductance or the resistance greater than 0 ohm. 2. Whether the vibration work of 14.318 is normal, and the other two feet, voltage 1.5-1.6 V. 3. Power - ok has 5V voltage, if not, follow the circuit to check the circuit. 4. If the clock signal of nanqiao is normal, the voltage of 330,220,110 is 1.6v. 5. The power supply of nanqiao should be normal, the quantity of MOS, 1117 has no 3.3 or 5V power supply. 6. Measure 32.768 crystal oscillator is normal Intel 0.5 V VIA 1.5v 7, the amount of the voltage on the reset switch is 3.3 V or 5 V, if no voltage, down the switch circuit, generally leads to two gate, or a foot to the gate, another foot to the gate. 8. Detection of gate voltage 3.3 v-5v. 9. Amount PCI, AGB, IDE, I/O reset foot to have short circuit. 10. Is it normal to measure Vcore? 11. The amount of ATX power is 3.3 V, 12V, 5V is normal. Iii. FF maintenance 1. In normal condition of each group, the resistance value of each bus is measured. 2. CPU to the north bridge 32 root address line, 64 root of data line to the ground resistance 350-750. 3. The resistance value of the south bridge to the north bridge is 350-750. 4. The AD line of the south bridge to PCI should be the same. 5. Amount of BIOS clock, reset, AD line. 6. Brush the BIOS. 7. Clock IC power supply. 8. Power of memory. Mainboard maintenance process 1. PCB has physical damage 2. There is no burn mark 3. Whether the capacitor has leakage, drum pack, loose, etc 4. Pay attention to whether the main board has been welded 5. Whether there is a short circuit in the back of the PCB in the interface OK 6. See whether the main panel chipset suppo