串口连接线制作方法（Method of serial connection）.doc

串口连接线制作方法（Method of serial connection） Methods of serial connection, s7-200 common problem analysis, PLC programming cable wiring diagram Update time: 2008-11-30 11:40:12 browsing time: 2932 USB - CNV3 Fuji programming cable use manual Summary: USB - CNV3 is provided via USB serial connection and RS422 programming cable, signal conversion under the control of the driver running in the computer, USB interface of computer simulation into the traditional serial interface (commonly known as the COM), which use the existing various programming software, communication software and monitoring software applications. The power source of this cable is derived from the USB port, which is no longer powered by the PLCs programming port, and the dual-color leds on the converted box indicate the status of the receiving and receiving of the data. The USB - CNV3 programming cable is available for the Fuji N series (NB, NJ, NS) PLC and supports maximum communication distance of 1.5 km. USB - CNV3 cable profile structure: Characteristics and technical indicators: ? Support for USB - CNV3 operating system: Windows 2000 / XP (winnt4/95/98 / Me/DOS not support) ? Support for USB - CNV3 programming software version: Flex V1.0 and above ? Fully compatible with USB V1.1 and USB CDC V1.1 specifications ? The USB bus is powered by a current of about 50mA ? Baud rate: 300bps ~ 1Mbps standard baud rate automatically ADAPTS ? Support UART data format: 7, 8, stop position: 1, 2, check bit: odd/even/no parity ? Support for long-distance communication, maximum communication distance of 1.5km (19200bps) ? Each PC supports only one USB programming cable ? Working temperature: - 20 ~ + 75 ℃ ? Cable length: 3 m, color: black Usage: USB cable - CNV3 programming need to install the USB device driver to use, the drivers are included on the CD attached with the release of the product, installation method please see documentation on the driver CD data, here is no longer here. Driver installation is complete