命题考点十一 《混凝土结构工程施工质量验收规范》中的相关规定（The relevant provisions of the acceptance criterion for construction quality of concrete structures）.docVIP

命题考点十一 《混凝土结构工程施工质量验收规范》中的相关规定（The relevant provisions of the acceptance criterion for construction quality of concrete structures） The relevant provisions of the acceptance criterion for construction quality of concrete structures [textbook interpretation] 1. Template sub-item engineering (1) the template and its brackets shall be based on the engineering structure, the load size and the foundation soil type; Construction equipment and materials supply and other conditions for design. The template and its bracket shall have sufficient bearing capacity, stiffness and stability to withstand the weight, lateral pressure and construction load of concreting concretes reliably. (2) the strength requirement of the concrete when the die is removed (see table 3-4). Second, the rebar project 1. Raw materials When reinforcing bars, check the product qualification certificate, the factory inspection report and the reinspection report. For the frame structure with seismic fortification requirement, the strength of the longitudinal force reinforcement should meet the design requirements. When the design does not have specific requirements, the strength measured value of the inspection shall meet the following requirements for a level of aseismic resistance level. (1) the ratio between the measured value of the tensile strength of the steel bar and the yield strength measured value should not be less than 1.25. (2) the ratio between the measured value of the yield strength and the strength standard value should not be greater than 1.3. 2. Reinforcement processing (1) the bending and bending of the force bars shall meet the following requirements. 1) the end of the HPB235 steel bar should be 180. Hook; The diameter of the curved arc should not be less than 2.5 times the diameter of the steel bar, and the length of the curved hook should not be less than three times the diameter of the steel bar. 2) when the design requires the end of the steel bar, 135. When bending hook, the diam