喷砂与喷塑（Sandblasting and spraying）.docVIP

喷砂与喷塑（Sandblasting and spraying） Sandblasting and spraying process Brief introduction of sandblasting technology Sandblasting is using compressed air as the power, to form a high-speed jet beam of the spraying material (copper ore, quartz sand, emery, iron sand, sea sand) high-speed jet to be handles the workpiece surface, make the appearance on the surface of the workpiece surface appearance or shape change, due to the abrasive impact to the surface and the cutting effect, make the surface of the workpiece by a certain cleanness and different roughness, the workpiece can improve the mechanical properties of the surface, thus improve the fatigue resistance of the workpiece, increase the adhesion between the coating and its, extend the durability of the coating, but also to the flow of paint and decoration. The sandblasting process has the following characteristics compared with other cleaning techniques such as pickling and tool cleaning. One, sandblasting treatment is the most thorough, the most common, the most rapid, the most efficient cleaning method. 2. Sand blasting can choose between different roughness, and no other process can achieve this. Manual polishing can be used to produce hairy surface but slow speed. Chemical solvent cleaning is too smooth to clean the coating. Sandblasting mainly has the following applications: (1) the workpiece is coated and the workpiece is adhered to before Sandblasting to scale on the surface of the workpiece and all dirt removed, and on the base of workpiece surface it is very important to build schemata (usually the so-called hair side), but also by changing different particle size of abrasive, to varying degrees of roughness, greatly improve the workpiece and the adhesion strength of the coating, plating materials. Or make the adhesion of adhesive pieces stronger and better quality. (2) cleaning and polishing of the part of the cast forging part, after heat treatment Sandblasting can clean up all the dirt on the surface of