螺纹编程（Thread programming）.doc

螺纹编程（Thread programming） Tutorial of introduction to ANSYS (18) - geometric modeling examples (a springs and screws) 2010-08-10 08:49:58| classification: ANSYS entry based | label: examples of spring screw thread size | subscription 2.6 examples of geometric modeling 2.6.1 spring According to mechanical behavior, the spring can be divided into compression spring, stretching spring, torsion spring and bending spring. According to the spring shape, it can be divided into spiral spring, butterfly spring, annular spring and leaf spring according to the spring shape. Only the mechanics analysis of single spring, simulated by 3D solid element in various mechanical behavior and parameter analysis of the spring; if the joint analysis of the spring and spring element structure, can be used by a single entity, in fact, constant spring or spring factory analysis parameters by itself. The pitch of the cylindrical compression spring is different from that of the drawing spring, but the modeling method is the same. The basic methods are to drag the creation body along the path using the surface, and the ANSYS command is numerous, and the specific methods can be varied. Modeling of 1. round coil cylindrical helical springs When the number of cycles is completed, the method of modeling springs can first create a 1/2 helix, then generate a circle of spirals with symmetry, create a spring cross section at the end of the helix, and then drag along the path The surface creates a loop of spring body and generates other parts by copying the body. Example: Geometric modeling of ex2.1A- full circle number cylindrical helical springs Finish $/clear $/prep7 The 1. parameter ------------------------------------------------------------------------------------- definition of spring! D=4 spring wire diameter C=8! Winding ratio, diameter of spring wire, winding ratio range is not the same N=10, the number of turns (integer), that is, the number of turns of the helix Dz=c*d the middle diameter of