高级汽车修理工试卷5（Senior auto engineer 5）.docVIP

高级汽车修理工试卷5（Senior auto engineer 5） A choice (first to 60 questions. Choose the right answer to the corresponding question in the letters in parentheses. 1 points for each question. Out of 60 points): 1. the actual cycle, instead of ideal cycle constant volume heat release process is (). (A) exchange process (B) intake process (C) exhaust process (D) compression process 2. reasonably determine the distribution phase in order to (). (A) (B) increase the intake air quantity of discharging exhaust gas (C) A and B (D) to improve the engine economy 3. in order to improve the charging efficiency, should reduce the intake system resistance, in the intake system, the minimum section (through), and changing the maximum flow resistance should be considered first. (A) the intake valve (B) carburetor (C) intake pipe air filter (D) 4. the optimal ignition advance angle increases with the speed increasing (). (A) increased (B) constant (C) decreased (D) decreased first and then increased. 5. when the engine works, if cut off the ignition switch, ignition engine can still run, this may be caused by the (). (A) surface ignition (B) combustion (C) high voltage high (D) mixture too thick 6. diesel engine in the combustion process, the maximum temperature of the formation is in the (). (A) the ignition delay (B) rapid combustion period (C) slow burning period (D) combustion period 7. diesel engine exhaust smoke is one of the main reasons is (). (A) (B) injection time early fuel injection time too late (C) the injection quantity is too small (D) rapid combustion period is too short The effective index of the 8. evaluation of fuel economy is the effective fuel consumption rate and (). (A) effective power (B) effective thermal efficiency (C) effective torque (D) mean effective pressure 9. car engine should be maintained at () work, the torque and power are large, low fuel consumption. (A) high speed (B) (C) (D) high speed 10. according to the characteristics of the ignition advance angle