UT题库（UT question bank）.docVIP

UT题库（UT question bank） 1. Non-topic (30) 1. Since mechanical waves are produced by mechanical vibrations, the fluctuation frequency is equal to the vibration frequency. Based on the results of the test results of the Angle reflectivity, it is concluded that the detection of single side welds by K is greater than 1.5, which is low in sensitivity and may cause leakage detection. 3. Because the ultrasonic wave is produced by mechanical vibration, the propagation speed of ultrasonic in the medium is the vibration velocity of the particle. 4. When the temperature of water rises, the propagation speed of the ultrasonic wave in water also increases. 5. When ultrasonic wave is injected into the heterogeneous interface, the sound pressure reciprocating transmission rate is equal to the sound transmission rate. 6. The refractive Angle of the same wave type is always greater than the incident Angle when the ultrasonic slanting enters the heterogeneous interface. 7, the same area, the same frequency of the round chip and the square chip, and the sound beam points to the same Angle. 8. The shorter the field length of the ultrasonic field, the better the sound beam directivity. 9. When the hollow cylinder is tested, the echo sound pressure of the bottom surface is lower than that of the simultaneous plane. 10. Compared with the lead zirconium titanate, quartz used as the piezoelectric material has the advantages of stable performance, high coefficient of electromechanical coupling coefficient and low energy loss of piezoelectric conversion. 11. The transmitting circuit in the detector can also generate several hundred volts of electrical impulses to stimulate the vibration of the probe. A series of series of tests is applied to inspect flat defects perpendicular to the plane. 13. In actual detection, the sensitivity of the flaw detection should be reduced appropriately to improve the decrease of scanning speed. 14. When the water immersion focusing method of steel pipe is injured