沉降观测规范（Settlement observation specification）.docVIP

沉降观测规范（Settlement observation specification） The calculation method of the interior area of the building Setting and observation points of settlement observation point of construction (construction) Building structure 10:09 reading comments 0 font size: 82 82 in greatly small settlement observation in building construction, as well as monitoring after the completion of the final acceptance of the process, have safety prediction, the function of scientific evaluation and inspection of construction quality, etc. The feedback information of on-site monitoring data can be used to forecast the construction process and other problems, and make reasonable technical decisions and on-site contingency decision in time. I. relevant normative and normative document requirements Approved by the ministry of construction (gb50026-2007) as the national standard, it has been implemented since 1 May 2008. Among them, articles 5.3.43 (1), 7.1.7, 7.5.6 and 10.1.10 (paragraphs) are compulsory and must be strictly enforced. The building deformation measurement specification (jgj8-2007) is the industry standard and has been implemented since March 1, 2008. Among them, article 3.0.1 and 3.0.11 are mandatory and must be strictly implemented. The original engineering measurement specification (gb50026-93) and the building deformation measurement procedures (JGJ/t8-97) were also repealed. In addition, the examination and approval of the construction department of jiangsu province, to determine the building settlement observation method (DGJ32 / J16-2006) as the mandatory project construction standards, jiangsu province, June 1, 2006, the main specification is currently the province building subsidence observation reference basis. In April 2008, kunshan city construction industry associations about the merit of engineering is used to detect the thickness of the cast-in-place floor slab thickness, steel protective layer, and the building settlement observation notice (quinn JianXie word (2008)