胶衣-不饱和聚酯（Gel - unsaturated polyester）.docVIP

胶衣-不饱和聚酯（Gel - unsaturated polyester） Gel coat English name gel coat, it is unsaturated polyester (UP) glass steel added pigment and thixotropic agent dispersed into (FRP) coloring thixotropy and mesa finish used to develop products. The use of gel coat The right choice of 1 type gel before use. 2 completely and thoroughly prepared mold, the mold surface determines the product surface. 3 before using the stirring barrel gel, but slower to avoid air bubbles. 4 before starting work, coating and mould temperature maintained at 16 DEG -30 DEG C, the mold temperature should be 2 degrees ideal - 3 C higher than the temperature of coating. So, after curing can get a more shiny coat surface. 5 the workshop relative humidity is less than 80%, the humidity will lead to improve the curing temperature. In addition to prevent water accumulation on the surface of the mould. 6 mold surface waxing fully, do not use mold release wax containing silicone type. Water soluble wax stripping must after the evaporation of water gel coating. 7 do not diluted solvent such as acetone. If it is used for low viscosity, can add a small amount of styrene (2%). 8 curing agent (MEKP) was generally in 1- 2%. If the amount of curing agent is too high or too low, will make the product water and weather resistance reduction. 9 such as paste, to ensure color uniformity and stability. According to the recommended amount, accurate weighing, using low shear mixing equipment. Can also use color gel coat. The gel coat resin and styrene Gel coat resin is the production of glass steel products. With lipid gel coat. Styrene monomer is the most suitable choice of UP resin. Styrene at room temperature but the steam pressure is higher, volatile, especially in the hand or injection molding process, production of glass and steel products, coating layer and the backing layer enhancement process more volatile. When the steam concentration exceeds a certain number (more than 50Pg/g), will stimulate the human eye nasal