结构布置（Structural arrangement）.docVIP

结构布置（Structural arrangement） Structural arrangement Classification: | Tags: Architectural Design Architectural Design The description of the structural design Design is mainly based on seismic grade, levels of civil air defense, and the bearing capacity of the foundation, moisture-proof, the value of live load, material grade, matters needing attention in the construction with details, general details or nodes, as well as in the construction not shown in the figure to express through that information. Such as: positive and negative below zero should be used in cement mortar, the mortar mixed above. Wait。 The structure arrangement of the 2. layers of the map, including: (1). The precast slab layout (plate selection, slab size and reinforcement). Mark number and type of the precast slab, do not use diagonal form. Because this method is easy to cause the cross line method, should adopt the horizontal or vertical line, the same type of room standard room type no.. The whole floor should be a unified code, designed to reduce the workload, also facilitate the construction of the plug-in staff. As far as the seam 40, the seam unworthy of the muscle or with a rib. The room layout from the inside out, as far as possible the use of wide plate slab with in the window, the best bandwidth of more than 200 cast-in-place slab (considering the riser wear plate plumbing). If the entire water layer construction requirements, seams should be greater than 60. The whole cast a thick layer of 50, with two 6@250 diameter, concrete C20. The transverse and longitudinal cross wall or wall (transverse wall) hybrid bearing scheme, anti collapse performance. Structural column shall not block cloth. Recommend the use of artificial PMCAD layout function cloth panels, automatic layout may not meet the requirements of the construction plans, can only meet the requirements of load transfer route definition. Very sensitive to the floor clear height, over a span of 6.9 meters or not in line with the m