细木工工程验收规范（Code for acceptance of joinery Engineering）.doc

细木工工程验收规范（Code for acceptance of joinery Engineering） Code for acceptance of joinery Engineering general provisions Suitable for fine wood, wood partition, and high-grade production of fixed furniture decoration and installation engineering. Inspection quantity: perception survey, allowable deviation items, random inspection, 20% of the total amount. Products made of a variety of materials must be implemented in accordance with the corresponding technical standards. The wood materials and accessories and spare parts varieties, quality, grade, type, size and color must meet the design requirements of the existing provisions of construction acceptance standards and product technology. Small wood with wood should meet the following requirements: Less than 12% 1, the moisture content of wood (gluing pieces of wood moisture content of 8 - 10%); 2, wood twill degree = inclined length of horizontal length is less than or equal to 20% X100%; 3. No rotten or insect eaten wood shall be used; 4, the appearance of timber joint diameter is less than or equal to 15 material width or thickness, and the maximum diameter of less than 5mm; 5, appearance materials shall not have dead section, worms eyes and cracks; 6, the internal materials of the joint diameter is less than or equal to 14 wide material or thick, and the maximum diameter is less than or equal to 20mm; 7, the length of the internal material crack is not greater than the length of the component: through crack 10%, non through crack 15%; 8, the internal materials of blunt edge local thickness is less than or equal to 14 material thickness, width less than 15 wide material; 9, coating parts or storage parts may not have resin bag; 10, the appearance of timber species should be single, timber stability, texture similar, symmetrical; 11, the same glue pieces of tree species, texture should be similar; 12. The panels should be lined with strips of similar texture. The embedded parts should be treated in accordance with the r