电气检修（Electrical overhaul）.doc

电气检修（Electrical overhaul） preview First, fill in the blanks: 1. high voltage circuit breaker can not only cut off the high voltage circuit or closed (the no-load current) and (load current), and when a fault occurs, the (relay) role, cut off (load current) and (ISC). 2. load switch also has an obvious (disconnection point), there are certain (drying capacity), can (load) operation, but not directly disconnect (short-circuit current). 3. is prohibited in the only (circuit breaker) disconnect the power supply equipment; must be opened (switch), at least one obvious to all aspects (disconnection point). 4. neutral grounded system, called (grounded) system; neutral indirectly grounding power system, called (small current grounding system). 5. current transformer and relay wiring are commonly used (star), (incomplete star connection), (phase differential current connection, delta connection). 6. transformer oil in the transformer (insulation), play (ARC) and function (cooling). The 7. main transformer switch power supply and stop order operation, when the power to stop (the load side of the switch), stop (power sensor switch); power supply and the order (opposite). The 8. basic requirements of relay protection device is (selective), (fast), (sensitivity), (reliability). The 9. pole DC system grounding, can continue to (run), two case of grounding will cause the relay protection (mal). 10. in the substation two circuit diagram, YBM (warning signal) small bus symbols, the accident sound signal symbols for small bus (SYM). 11. in the circuit breaker control circuit, TWJ (tripping position relay) symbol, TBJ (anti jump relay) symbols. 12.SF6 is a kind of gas (colorless), (odorless), (non-toxic), non flammable (inert gas). 13. when the SF6 gas pressure inside SF6 breaker is lower than that of Mpa (0.4), a signal loop blocking signal, the prohibition of circuit breakers (SWITCHING) operation. 14. in the actual operation, the arc suppression coil should be avoided (compensation