画图布线（Drawing wiring）.docVIP

画图布线（Drawing wiring） How to set the jumper in the Altium Designer single panel PCB? The jumper can use 2 pads or 2PIN pins Set the start to end of the pad, and then draw a line in the mechanical layer generation jumper. A circuit board design, pre preparation work 1, drawing principle diagram and table corresponding to the generated network. The design may not have been the case principle diagram of network table, directly into the PCB system design. 2, manual change network table will not fixed with foot principle diagram of some components of the pads on the definition and a connected network. Some consistent principle diagram and pin PCB package library is not the same as the name of the name changed to the device pins and PCB package library, especially the two triode, etc.. Two, draw the non standard device package library defined by myself That will own the painting device in a PCB library to establish their own special design documents. Three, set the PCB design environment and drawing of the printed circuit plate with a middle hollow. The first step 1, enter the PCB system is to set up the PCB design environment, including setting the lattice size and type of cursor type, plate layer parameters, layout parameters and so on. Most of the parameters can use the system default values, and these parameters are set, according to personal habits, after no longer need to modify. 2, planning is to determine the main frame circuit board, circuit board, including circuit board size etc.. Placing a fixing hole on the need to put in place on the appropriate size of the pad. The pad 3mm screws can 6.5~8mm outer diameter and the inner diameter of 3.2~3.5mm. Four, open all the use of the PCB library file, transferred to the network table file and modify parts package This step is a very important link, the network table is PCB automatic routing of the soul, is the principle of interface design and circuit board design, only the network table can be loaded, wiring circuit bo