板柱（Plate column）.doc

板柱（Plate column） Slab column structure is often used in architecture, it has many advantages, such as the construction of formwork and steel banding is relatively simple, the height of the smaller structures, can reduce building height, thereby reducing the cost of buildings and so on, but because of the structure subjected to strong earthquake, the seismic behavior of slab column connections as a beam column beam, in addition, unbalanced moment to pass by the joints caused by seismic activity, it will produce stress in column periphery, when shear stress is large and the lack of effective measures of shearing, possible punching failure, and even lead to continuous damage of structure. Therefore, the new seismic code has made strict regulations on the applicable height of the slab column seismic wall structure. However, in actual engineering, there are still a large number of requirements for the plate column structure. The purpose of this paper is to provide some measures to make the slab column structure higher enough to meet the actual needs. Okok.org Examples of earthquake damage (omitted) okok.org The slab column structure (no seismic wall) poor seismic performance, Beijing Architectural Design Institute published in 1992 technical measures stipulated in the structure, the seismic fortification intensity is 6 degree area of not more than four layers of high layer, housing a total of not more than 16m, 7 degrees is three and 12M, 8 of two layer and 8m. (the above refers to the slab column structure without shear wall) new seismic code GB50011-2001 stipulates strictly for slab column structure for example, for the maximum height, 6, 7, 8 of the area were 40, 35, 30 meters; shear wall should be able to bear all the earthquake, plate part additional bear all the earthquake of 20%; the two principal directions of the column section of the bottom plate continuous bar, there are a number of requirements (seismic code 6.6.9) and so on. Okok.org In the seismic code tabl