搅拌站资料（Mixing station data）.docVIP

搅拌站资料（Mixing station data） 1, mixing station production management system The station did not command production owners or project manager department issued no startup concrete mixing. It has no project department license shall not stop production or stop production repair. The accurate input proportion; carefully retest all data entry, the test personnel, the operator after confirmation signed by the record, before production. In strict accordance with the production, no laboratory test personnel written instructions, no one is allowed to arbitrarily increase or decrease of raw materials, additives and water use. The mixing time depends on the state, shall not arbitrarily or without the consent of the test personnel. The production should be closely observed, measurement error exceeds the prescribed should adjust the gap. All measurement at no-load, should be in the range of the minimum value. Measuring system of other abnormal situation must timely report processing. Such as cement, admixture, water error can not exceed 1%, cement, admixture quality is not enough, should be timely to find the auger is blocked, and promptly eliminate, aggregate error can not exceed + 2%, should be timely to find the reasons and manual compensation and record when the error exceed the standard time. Water discharging, discharging port and tank inlet should be aligned, stop discharging omission. According to the end of the process, the following closed switch: The pump power switch; The main power switch; The general control switch; The additive pump switch; The air compressor switch; Only after the work is completed within two hours, will host all contact parts of the concrete clean, must not appear for a period of time the cumulative raids phenomenon. That fails in concrete production, immediately manually unloading, and cleaning related parts. According to his instructions strictly enforce the mixing station. Every time we start formal production and maintenance personnel must be