梁平法（Liangpingfa）.docVIP

梁平法（Liangpingfa） Working drawings generated by working drawings generated by same section plane and write note note written in two ways. When the beam is a special-shaped section, it can be written in sections, otherwise it should be written in plane. The beam layout shall be plotted in proportion to the standard layer, including all beams, columns, walls, and panels. For beams not centered on the axis, the location dimensions shall be marked (Liang Chuwai on the side of the column). When the layout of the Departments beams is too close, the dense area can be framed in a dotted line, enlarged or enlarged, or separated from the vertical and horizontal beams on the two drawing. Similarly, in Liangping method in the construction drawing, should adopt the form or otherwise indicate the top elevation of each structural layer and corresponding structure layer number. The note is in the writing section, beam layout drawing of the standard layer, from the different number of each beam of a beam with a section number leads to reinforcement figure and the note writing section and reinforcement of numerical. The section annotation method can be used either alone or in combination with plane writing. The plane note writing, is in the beam layout, the number of different beams of each pick one and the note writing section and reinforcement of numerical. Planar annotation includes centralized tagging and in situ tagging. The beam numbers, section sizes and reinforcement of the beams are represented by many cross - in - situ marking elements, representing only the span. Specific expressions are as follows: The beam number and multi span general beam section size, stirrups and cross gluten basic value marked by concentration, from the beam of an arbitrary cross lead note writing; beam bottom reinforcement and bearing are used in situ labeling of gluten. The cross sectional dimension, stirrups, mid span gluten and waist rib of different span beam can be marked in situ. The number of