慢走丝工作（Slow wire work）.docVIP

慢走丝工作（Slow wire work） Slow wire work Plastic mold: insert, oblique top, front and rear mold Ren, copper gong. KP die: punch, B1 plate, A1 board. Hardware: punch, edge, forming insert, 106, 105, 103. Machine tools: No. 9, No. 10, No. 11 and No. 12 machine tools, using 0. 25 copper wire, others with 0. 20 copper wire. Resin: a machine has two cans, a can of a package of half, share three bags, can use 30 days to 40 days or so. Filter: 30 days to 40 days for a time, one machine has 4 filter. Copper wire: a coil of copper wire for about two days and two nights, about two times a week, 0. 25 lead 3 cases, 0. 2 lead 4 cases, one coil copper wire, 5KG, one case 20KG. {instructions for each discharge parameter} The number of SNO: \ VO: discharge voltage discharge cutting conditions, big - small - fast, slow, commonly used by 60 - 150V \ VG: gap voltage, fast - smooth, slowly - smooth, commonly used by 35 - 50V \ SG: servo sensitivity, servo control parameters, workpiece thin - fast food instability, slow - - small workpiece thickness is stable, used by 5 - 20, CS: cutting current selection of rough machining or finish machining, DC power set, the crude 0- current, 10- current, 20-24- current young AC power set, the crude 101102- current, 110- current, 120-124- current young, high frequency 30-33- the current \ I: 1-15 \ OFF cutting current, pulse off time, commonly used by 10-30 \ HS high speed function, fast slow, small, commonly used by the 1 - 31 \ WS 1-99 \ WT wire speed, wire tension, 1-99 \ FL 111-117 high pressure jet, fine water level seven, 121-127 were seven, total fourteen \ S/ F automatic / constant speed selection, 0- automatic, 1- constant speed \ F, constant speed, processing speed \ N, effective discharge rate, 68-, coarse, 40-, young, 0- high frequency Search for discharge conditions in the system In the condition menu, select the system, and the cutting condition / system screen will be displayed To search for the best cut order as follows: 1) 2) in the sy