发光二极管的相关知识（Knowledge of LED）.docVIP

发光二极管的相关知识（Knowledge of LED） Light emitting diode.Txt related knowledge, I do not expect what, just wish you a woman as one. I remember when ah, hot days when I can be like a shirtless man! Two) the characteristics of LED 1. limit values (1) the maximum allowable power dissipation on both ends of LED Pm: allows the positive DC voltage and the current flowing through it is the product of the. More than this value, LED fever, damage. (2) the maximum positive DC current IFm: maximum positive direct current with the permit. More than this value can damage the diodes. (3) the maximum reverse voltage VRm: maximum reverse voltage allowed by the. More than this value, the light emitting diode may be breakdown. (4) the ambient temperature range of the working environment of topm: light emitting diode working. Below or above this temperature range, the light emitting diode will not work properly, the efficiency is greatly reduced. 2. the electrical parameters of the significance (1) the spectral distribution and peak wavelength: issued by a light emitting diode is not a single wavelength, the wavelength of the body as shown in Figure 2. The figure shows a 0 wavelength of light intensity of the luminous tube are made in the light of the wavelength of the peak wavelength of the maximum. (2): IV luminous intensity luminous intensity of light emitting diode (usually cylindrical luminous tube fingering line refers to the axis direction of the luminous intensity). If in the direction of radiation intensity of (1/683) W/sr, the light emitting 1 Candela (symbol CD). Because of the general LED two luminous intensity is small, so the light intensity used Candela (MCD) unit. (3) spectral half width delta lambda: it represents the spectral purity of the luminous tube. Refer to figure 3 1/2 peak intensity corresponding to two wavelength interval. (4) half value angle 1/2 and angle theta: 1/2 is the luminous intensity values of half axial strength and axial direction of light (normal) angl