大连理工2012年秋《钢筋混凝土结构》在线作业1及答案1（Online construction of reinforced concrete structure in 2012 autumn, 1, and answer 1）.docVIP

大连理工2012年秋《钢筋混凝土结构》在线作业1及答案1（Online construction of reinforced concrete structure in 2012 autumn, 1, and answer 1） A RadioButtonList 1. structure within the specified time, under specified conditions to complete a predetermined probability function is called (). A. safety B. reliability The reliability of C. The target reliability index D. 2. structural service life over the design life (after). A. immediately lost its function B. reliability decreases C. not failure, and constant reliability D. cannot be determined 3. concrete a short-term loading of the compressive stress - strain curves of the following statements is true (). A. ascent is a straight line. B. is only measured at low intensity on experimental machine C. concrete strength is high, the peak curve of the rate of small steps D. concrete compressive stress reaches the maximum, is not immediately destroyed 4. with the bonding ability between steel bar and concrete (rib). A. is a little higher than the round steel bar B. depends on the diameter of reinforcing steel bar C. is a convex surface of the steel rib. D. cannot be determined Normal section bending bending is in the following 5. under normal use (RC). A. is the first stage of the work, there is no crack B. is the second stage of the work, or work with cracks C. in the third stage, the longitudinal tensile reinforcement has yield D. cannot be determined Two, multiple-choice questions 1. for creep of concrete, the following views are correct (). A. is all plastic deformation and creep B. is full of elastic deformation and creep C. creep includes both plastic deformation and elastic deformation D. in different load, with the load time and increase the strain growth 2. of the reinforced beam, just by the yield of tensile steel, is (). To achieve the ultimate bearing capacity of A. B. steel reached the limit strain The C. strain is less than the ultimate strain of concrete The compression of D. edge concrete is crushed Three, to determine the problem Th