pkpm电算问题（PKPM computing problem）.docVIP

pkpm电算问题（PKPM computing problem） PKPM computing problems, 2009-08-18, 10:001, total information value: prerequisite, very important, otherwise meaningless calculation. 1) concrete density should be 27 to 30 beams, columns and shear walls considering paint or decorative surface layer after the bulk density should be 25kN/m3, such as noodles 20 thick mortar, column 400 x 400: = gamma (4402-4002) * 20/4002+25=4.2+25=29.2, 600 * 600 column: gamma = (6402-6002) * 20/6002+25=2.7555+ 25=27.8. Column 1000 x 1000: = gamma (10402-10002) x 20/10002+25=1.632+25=26.632, 250 x 500 beam (plate thickness as 100mm (290): y = x 420-250 x 400) * 20/ (250 * 500) * 800 (300 +25=3.488+25=28.5, beam plate thickness as 100mm (340): y = x 720-300 x 700) * 20/ (300 * 800) +25=2.9+25=27.9, shear wall thickness of 200 y =40 x 20/200+25=4+25=29, wall thickness of 300 y =40 x 20/300+25=2.67+25=27.67, visible, beam, column and shear wall section size is instead of larger, such as tiles, granite, but also increase the bulk density, design One should consider the section size and the surface material of the beam, column and shear wall of the project comprehensively, and determine a more suitable density of concrete. 2) the cycle reduction coefficient Tc: reduction, otherwise the earthquake should be small, depending on how much this project filled wall to determine the cycle reduction coefficient of filling wall for small value, less filling wall value of high building technical specification for concrete structures of JGJ 3 - 2002 3.3.16 rule the structure of each mode is calculated by using the seismic influence coefficient of natural period of vibration should be considered to be non bearing wall stiffness reduction is the mandatory provisions, the general framework from 0.6 to 0.9, the shear wall structure from 0.9 to 0.99, from 0.7 to 0.9 frame shear wall structure, high gauge shear wall 0.9 to the provisions of article 3.3.17 the 1 is wrong, should be 0.9 ~ 0.99, 1 is not reduced, is not in v