stl文件（stl file）.docVIP

stl文件（stl file） Hierarchical processing of STL files (slicing) Rapid prototyping is based on the principle of discrete accumulation molding. Both discrete and stacked are related to slice processing. When discrete, the CAD entity model is divided into many layers, namely slicing or slicing. When stacked, the slice is divided into solid model. Therefore, rapid prototyping is also called Manufacturing (Layered). Layered technology is the core technology of rapid prototyping technology. To understand the rapid prototyping technology, the basic principle of layered technology must be mastered. This section will give a brief introduction to the working principle of layered technology. Hierarchical processing is the main purpose of the 3D complex shape into a simple 2D contour line (Contour), and then according to the cutting out of the 2D contour lines made of prototype, and the layer thickness between 0.05mm-0.3mm between. The following is the principle of hierarchical processing. The thickness of the surface layer of the layered molding has considerable influence, still when the cutting surface in the effect will be very significant. Although the thickness of the layer has been 0.1mm, but as the degree of isolation gradually increases, the Error (Staircase) will become more and more obvious, and because of this reason, the defects will appear completely after molding. In fact, this is based on the fundamental problems that arise when forming, and is inevitable. Affected by this basic problem, the error in rapid prototyping in Z direction is higher than that in X and Y. In order to improve the error caused by the layered steps, two major solutions are put forward: (1) adaptive layering Because the error caused by stratification can be said to be inevitable. To reduce the thickness of layers can reduce the influence of step effect, but the thickness directly affects the machining area rate, rapid prototyping method and the thickness of a certain limit, so by reducing the