DESIGN OF ANCHOR BOLTS EMBEDDED IN （螺栓设计嵌入）.pdf

A n i n f o r m a t i o n s e r i e s f r o m t h e n a t i o n a l a u t h o r i t y o n c o n c r e t e m a s o n r y t e c h n o l o g y DESIGN OF ANCHOR BOLTS EMBEDDED IN TEK 12-3C CONCRETE MASONRY Reinforcement Connectors (2013) INTRODUCTION The function of anchor bolts is to transfer loads to the • Headed anchors include conventional square head or hexhead masonry from attachments such as ledgers, sills, and bearing threaded bolts, but also include plate anchors (where a steel plates. Both shear and tension are transferred through anchor plate is welded to the end of the bolt). Headed anchor bolts bolts to resist design forces such as uplift due to wind at the must meet the requirements of Standard Specification for top of a column or wall or vertical gravity loads on ledgers Carbon Steel Bolts and Studs, 60,000 psi Tensile Strength, supporting joists or trusses (see Figure 1). The magnitude of ASTM A307, Grade A (ref. 7). these loads varies significantly with the application. For other anchor bolt configurations, including post- This TEK summarizes the requirements to properly design, installed anchors, design loads are determined from testing a detail and install anchor bolts embedded in concrete masonry minimum of five specimens in accordance with Standard Test construction based on the provisions of the 2013 edition of Methods for Strength of Anchors in Concrete and Masonry Building Code Requirements for Masonry Structures (ref. 1). Elements, ASTM E488 (ref. 8) under stresses and conditions It should