Higher Level Leaving Cert Engineering RT201; （更高级别的离开Cert工程 rt 201;）.pdf

Higher Level Leaving Cert Engineering (Answer Question 1 - Section A and Section B and four other questions) Higher Level Engineering (Remember 50% of the Exam is already complete with Practical and Project) Project 150 marks 25% Practical 150 marks 25% Theory 300 marks 50% Read the paper fully before you start answering any questions, select your questions carefully. Do not leave the exam early. Do any extra question if you have extra time. Examiner will mark all answers. Answer Question 1 - Section A and Section B and four other questions Draw diagrams in pencil to help illustrate your answer and label diagrams. Draw neat and accurate graphs. Start each question on a new page and label all parts clearly. Use bullet points. Look over past exam papers, marking schemes and sample answers on www.examinations.ie QUESTION 1 SECTION A AND SECTION B ARE COMPULSORY Section 1 (Short Questions – Summary of the Course, look over past exam papers, marking schemes and sample answers on www.examinations.ie) • Safety symbols, safety with toxic materials, effects of toxic materials, disposal of waste plastic • Corrosion, sacrificial protection, oxidation, electro-chemical corrosion, environment corrosion, protection against corrosion – protective coating (paint, plastic dipping), anodising of aluminium, hot dipping, electro painting, galvanising • Joining materials with adhesives, preparing materials for joining with adhesives, joint design, types of adhesives, safety hazards when using adhesives • Joining Methods – Mechanical Joining (screw fasteners, compression joints, riveting, sheet metal folding), Welding, Bonding (soldering, brazing, adhesive bonding) • Manufacturing processes – drop forging, calendaring, casting (pattern), sand casting, investment ‘lost wax’ casting, die cast