INSTALLATION INSTRUCTIONS Crompton （安装说明,克朗普顿）.pdf

INSTALLATION INSTRUCTIONS Page 1 of 2 Paladin Transducers Ref: IW256TD/TF – Rev 5 – Sept 02 Class 0.5 Series 250 Power Factor Transducers Products Covered Side labels show full connection information and data, including 256-TFT 256-TDS Type No., Range, Voltage, Current, Frequencies, Auxiliary 256-TDT 256-TDB Supply (when required), Class Index and Output. 256-TDA 256-TDE Setting Up Introduction The units are adjusted before despatch but, should it be The power factor transducer measures phase between current necessary to trim the transducer output to suit system and voltage and gives an output proportional to the power factor. inaccuracy, this may be carried out by adjusting the Zero and span adjustments are accessible without opening the potentiometers located under the bungs on the front panel. It unit. should be noted that this might affect the accuracy of the product, The cases are moulded in a tough flame-retardant thermoplastic resulting in the need for re-calibration. material. Typical Applications Installation For measuring power factor between