POE Test 1 (Unit 1.1 Mechanisms) Wilson High （坡测试1(单位1.1机制)威尔逊高）.pdfVIP

Name: Period: POE – Test 1 (Unit 1.1 – Mechanisms) Multiple Choice Identify the choice that best completes the statement or answers the question. ____ 1. Study the gear train in Figure 6. The purpose of the center gear is to a. allow the drive and driven gear to rotate in the same direction. b. allow the drive and driven gear to rotate in opposite directions c. increase the output RPMs of the driven gear d. increase the output torque of the driven gear ____ 2. In a third class lever, the distance from the effort to the fulcrum is ____________ the distance from the load/resistance to the fulcrum. a. less than or equal to b. less than c. greater than d. greater than or equal to ____ 3. When used to pry open a can of paint, a screwdriver functions as a. a screw. b. an inclined plane. c. a wheel and axle. d. a lever. ____ 4. Given the pulley configuration shown below, what is the Ideal Mechanical Advantage of the system? 5 lbs. 5 lbs. a. 1 b. 2 c. 5 d. 10 10 lbs. ____ 5. A POE student is using the ramp shown in Figure 5 to raise an object 4 feet above the ground. The ideal mechanical advantage of the ramp is a. 0.316 b. 3.163 c. 1.05 d. 3.0 ____ 6. Figure 7 represents a belt driven system. Pulley B, which has a diameter of 16 inches, is being driven by pulley A, which has a diameter of 4 inches. If pulley A is spinning at 60 RPMs, th