在制造行业的应用.pptVIP

* * * * * * * * 手机中的马达,研究在手机跌落过程中上面偏心轮的最终变形,手机模型缺失 * * * * * * * * * * * * * * * * * * * * * * * In the global model, the case components, buttons, and wheel are meshed with modified 10-node tetrahedral elements. We called them C3D10M. These elements provide a robust solution during large deformation and contact analyses and exhibit minimal volumetric and shear locking tendencies. They are also advantageous in that they can be used with automatic tetrahedral mesh generators, thus easing the task of meshing the complex molded geometry typical in electronic components. The circuit board and electronic components are meshed with hexahedral elements. The electronic components are connected to the circuit board with surface-based tie constraints. The tie-type constraint rigidly bonds surfaces together, and these bonds cannot break during the analysis. The advantage of using tie-type constraints is that the meshes to be joined are not required to match, allowing the electronic components to have relatively coarse meshes. * The total forces in the forward base-to-middle housing fastener (shown in slide 4) are plotted in the Figure. The local X– and Z–components are shown; these correspond to axial and lateral shear forces, respectively. The local Y–component is zero due to symmetry. An additional curve is shown for each component for the case in which the failure of the connector was prevented. The model’s internal and kinetic energy histories are shown in the Figure . At the beginning of the simulation the mouse is in free fall; consequently, the kinetic energy accounts for the entire energy content. The initial impact deforms the case, transforming the kinetic energy into internal energy. Two additional curves are shown, one for each energy component for the case in which failure of the connector was not included. * * * * * * * * * * * * * * * * * * 图２-1 给出了插箱以及机柜的有限元模型。为了简化模型，分析中忽略了对强度影响不大的前后门以及其他部件，插箱单板均简化为质点的形式。按照试验要求，要分析的插箱安装在机柜最上端的位置，机柜下方空余位置也按照规定均匀分布一定质量的配重以模拟实际