练习7_连杆.PPTVIP

July 30, 1999 练习 7连杆 连杆 问题描述 使用自底向上方法对汽车连杆建模。 连杆 1. 进入ANSYS，工作路径为缺省，工作文件名为 “c-rod”。 2. 生成两个圆面: Main Menu Preprocessor -Modeling- Create -Areas- Circle By Dimensions ... RAD1 = 1.4 RAD2 = 1 THETA1 = 0 THETA2 = 180, then [Apply] Next, set THETA1 = 45, then [OK] Or issue: /PREP7 PCIRC,1.4,1,0,180 PCIRC,1.4,1,45,180 3. 打开面号: Utility Menu PlotCtrls Numbering ... Set Area numbers on, then [OK] Or issue: /PNUM,AREA,1 APLOT 连杆 4. 生成两个矩形面: Main Menu Preprocessor -Modeling- Create -Areas- Rectangle By Dimensions ... X1 = -0.3, X2 = 0.3, Y1 = 1.2, Y2 = 1.8, then [Apply] X1 = -1.8, X2 = -1.2,