Build Your Own Bob Beck Protocol（构建自己的鲍勃·贝克协议）.pdfVIP

Bob Beck Legacy How to Build Your Own The following schematic and instructions have been edited from the original handout that Bob Beck made available after his lectures. This handbook now called “The Beck Protocol”, is available as a free download or a hardcopy can be purchased. Download Beck Protocol Handbook Purchase Beck Protocol Handbook Note: These data are for informational and instructional purposes only and are not to be construed as medical advice. Consult with your licensed health practitioner. Thousands have been built successfully if duplicated exactly as shown. HOw to Build a Blood Electrification Unit Proposed Theoretical In-Vivo Blood Pathogen Neutralizing Device Revision November 24, 1996. Copyright © 1991/1996 Robert C. Beck, D.Sc. Revised July 2015 by Bob Beck Legacy Association Schematic by Bob Beck This 11/24/1996 page describes a ‘Plant Growth Stimulator’ improved since my 1991 design. User- tested for over two years, it is solid state (no relays), uses three (not seven) batteries, makes colloids, is much smaller, lighter, silent, with battery saving features. The ionic colloidal silver making function is included in the blood electrification schematic. (See Schematic on page 3) There are three methods for making ionic colloidal silver - Constant Current, Heating Water and Salt. For this design, the Heating Water Method and Salt Method can be used. The first section (U1A) of the LM358 dual OP Amp is a 54 (2 x 27 Volts peak per cycle) Volt peak- to-peak square wave oscillator. The second section (U1B) reverses polarity and provides ±27 Volts DC output of low impedance. This delivers a Bi-Phasic, sharp rise time output of ~4 Hz (not critical) for the biological cotton-covered stainless-steel electrodes saturated with salt water before applying. Sharp rise time is considere