clean inspect gasket install support（清洁检查垫片安装支持）.pdfVIP

clean inspect gasket install support Member BRITISH SAFETY COUNCIL PLATE REFURBISHMENT REMOVAL FROM SITE Our engineers are available to attend site to open heat exchangers and remove the existing plates and gaskets. INITIAL INSPECTION When the plates and gaskets arrive back at our works they are checked in against the customer’s specifi- cation and visually inspected for any damage. CHEMICAL CLEAN The plates are degasketed and dipped in a series of chemical baths to remove deposits and scale. They are then pressure washed and dried before being visually inspected for the second time. DYE PENETRANT TESTING The cleaned plates are sprayed with a fluorescent dye and inspected with an ultra violet lamp for pin holes and cracks. Before chemical clean Pinholes are revealed After chemical clean by UV inspection PLATE REPLACEMENT A report will be provided detailing any plate failures and recommendations will be made. Failed plates will be replaced with new plates following our customer’s instructions. REGASKETING Plates are regasketed with new gaskets and assembled in order ready to be fitted back into the heat exchanger frame. QUICK TURNAROUND Plates are usually available for despatch approximately 1 week after removal from site. INSTALLATION If required our engineers are available to attend site to fit the refurbished plates, tighten the heat exchanger to the appropriate dimension and test for leaks. HEAT TRANSFER PLATE IDENTIFICATION FLOW PLATE CHEVRO