Design and Analysis of Gas Turbine Blade by （燃气轮机叶片的设计和分析）.pdfVIP

V. Vijaya kumar et al Int. Journal of Engineering Research and Applications ISSN : 2248-9622, Vol. 4, Issue 1( Version 1), January 2014, pp. 187-192 RESEARCH ARTICLE OPEN ACCESS Design and Analysis of Gas Turbine Blade by Potential Flow Approach 1 2 3 V. Vijaya Kumar , R. Lalitha Narayana , Ch. Srinivas M. Tech Student Department of Mechanical Engineering A.S.R. College of Engineering Tanuku Head of the Department Department of Mechanical Engineering A.S.R. College of Engineering Tanuku Associate professor Department of Mechanical Engineering A.S.R. College of Engineering Tanuku ABSTRACT The design features of the turbine segment of the gas turbine have been taken from the “preliminary design of a power turbine for maximization of an existing turbojet engine”. It was observed that in the above design, after the rotor blades being designed they were analyzed only for the mechanical stresses. As the temperature has a significant effect on the overall stress in the rotor blades, a detailed study is carried out on the temperature effects to have a clear understanding of the combined mechanical and the thermal stresses. The first stage rotor blade of the gas turbine is analyzed for the mechanical axial and centrifugal forces. Knowing the fluid conditions at exit of the gas turbines, a value of static pressure was assumed at the turbine outlet. From this the corresponding enthalpy drop required in the power turbine is calculated. The peripheral speed of rotor and flows velocities is kept in the reasonable range so to minimize losses. In which the base profiles available and is analyzed later for flow conditions through any of the theoretical flow analysis methods such as “Potential flow Approach”. Key words: Ga