config ISDNBRI 15课件.pptVIP

Configuring ISDN BRI;State a relevant use and context for ISDN networking Identify ISDN protocols, function groups, reference points, and channels Relate Point-to-Point Protocol (PPP) and dial-on-demand routing (DDR) functions to ISDN Describe Cisco’s implementation of ISDN BRI Configure an ISDN call, open a circuit, and pass data over an interface Monitor and analyze ISDN operation through the router;ISDN BRI Overview;Uses higher-quality end-to-end digital facilities Sets up call faster than basic telephone service Carries varied feeds (for example, packets, voice, video) Meets demand for telecommuting bandwidth Improves Internet response (especially for World Wide Web);Routing over ISDN;Obtaining ISDN Services;Standards from the ITU (CCITT);LT;TE1;Customer Premises to ISDN;Cisco ISDN Features;1. Interesting packet arrives;Configuring ISDN BRI;ISDN Channels for BRI Are 2B+D;ISDN Configuration Tasks;Router (config) #;Router (config) #;interface bri interface-number;Router (config-if) #;Configuring for a Simple ISDN Call;! set up switch type, static route and dialer for ISDN on Cisco A isdn switch-type basic-5ess ip route 172.16.29.0 255.255.255.0 172.16.126.2 dialer-list 1 protocol ip permit ! ! configure BRI interface for PPP; set address and mask interface bri 0 encapsulation ppp ip address 172.16.126.1 255.255.255.0 ! ! refer to protocols in dialer-list to identify interesting packets dialer-group 1 ! ! select call start, stop, and other ISDN provider details dialer wait-for-carrier-time 15 dialer idle-timeout 300 isdn spid1 0145678912 ! call setup details for router dialer map ip 172.16.126.2 name cisco-b 526-1234;#show interface bri 0 1 BRI0: B-Channel 1 is up, line protocol is up  Hardware is BRI MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive not set lcp state = OPEN ncp ccp state = OPEN ncp ipcp state = OPEN ncp osicp state = NOT NEGOTIATED ncp ipxcp state