计算机集成制造系统(大).docx

计算机集成制造系统题 目： 协 同 装 配 设 计 学 院：专 业：姓 名：学 号： 年 级：任课教师：摘 要 随着现代产品复杂程度的提高，企业为了增强竞争力，在激烈的市场竞争环境下取得成功，必须缩短产品的开发周期和降低产品成本，提高产品的开发效率和经济效益。自顶向下协同装配设计是一种新的设计模式，新设计模式的采用给产品设计过程管理和规划带来了的挑战。本文以协同装配设计过程建模及规划技术为研究对象，通过分析协同装配设计过程特点，提出层次着色Petri网(HCPN)建模方法，以设计者的设计过程活动为建模对象，基于HCPN构建自顶向下协同装配设计过程的模型，以刻画设计过程的复杂行为特征，揭示设计过程的内涵特点。采用设计结构矩阵表达任务之间的关联关系，提出设计组承担的任务量均衡和分在同一任务组内的任务具有较高关联祸合度两个分组原则，并采用基于多目标的遗传优化算法，以实现任务的合理分组，达到缩短产品开发周期和设计组之间的交互量的目标。关键词：协同装配设计 过程规划 过程建模ABSTRCT With the improvement of modern product complexity, in order to enhance competitiveness, to success in the fierce market competition environment, must be shorten product development cycle and reduce the product cost, improve product development efficiency and economic benefits.Top-down collaborative assembly design is a kind of new design pattern, a new design pattern using brings to the product design process management and planning for the challenge.Based on collaborative assembly design process modeling and planning and technology as the research object, through analyzing the characteristics of the collaborative assembly design process, put forward hierarchy colored Petri net (HCPN) modeling method, the modeling object is the designers design process activities, based on HCPN top-down collaborative assembly design process model, in order to describe the design process of complex behavior characteristics, reveals the connotation of the design process.Using design structure matrix express the relationship between the task and puts forward the design team, undertake the task of volume balance and points at the same tasks within the task group has higher correlation disaster degree two grouping principles, and based on multi-objective genetic optimization algorithm, so as to realize the reasonable tasks grouping, to shorten product development cycle and design the interaction between the amount of goals.Keywords: collaborative assembly design ；process planning ； process modeling引言产品设计是一个将