冷旋压封头工艺守则（Code of procedure for cold - screw sealing head）.docVIP

冷旋压封头工艺守则（Code of procedure for cold - screw sealing head） Code of practice for cold - rotary sealing head Subject content and scope of application This standard specifies the cold spinning two-step production of pressure vessel, boiler and pressure vessel head blank preparation, blank processing, pressure drum, flanging, head eventually manufacturing requirements and testing methods, such as heat treatment, etc. This standard is applicable to all kinds of sealing heads of Dg800 ~ Dg5200 produced by our factory. 2. Reference standard Gb150-1998 steel pressure vessel JB/t4746-2002. 3. The basic requirements 3.1 The sealing head of the cold-spinning pressure vessel should meet the requirements of the safety technical inspection procedure of pressure vessel and GB150 and related drawings and process documents. 3.2 The material used for cold-spinning and sealing head is the metal material of carbon steel, low alloy steel and austenitic stainless steel. 4 Technical content Table 1 of the sealing head type and the size of billet is shown in table 1. 5 Billet prepared 5.1 Make head materials should hold documents, comply with the relevant standards of quality for pressure vessels and cryogenic vessels with head, the sheet should be consistent with GB150-1998 or JB4732-1995 regulations and pattern and process documentation requirements, should also conform to the pattern or order requirements of technical agreement. 5.2 The surface and blank processing end shall not have the defects such as spot, crack, and burr. 5.3 Makeup counterpart in the wrong side of the amount of b (see figure 1) shall not be greater than 10% of the steel plate thickness of the delta s, and no greater than 1.5 ㎜. The right and wrong side of the splice composite steel plate (see figure 2) is not larger than the steel plate ㎜ thickness of 3%, and no greater than 1. 5.4 Head manufacturing unit acceptance certificate shall be in accordance with the quality of steel plate, when necessary, also should unde