坡道式汽车库（Ramps garage）.docVIP

坡道式汽车库（Ramps garage） 4 ramps garage 4.2 design of ramps garage 4.2.1 the ramp type garage can be used in the internal and straight slope type, outside and outside of the library and inside and outside of the warehouse according to the specific conditions of the project; Single-line spiral ramps, double spiral ramps, and jump - layer spiral ramps; Two-stage and three-phase fault car library; And the straight slope Slanting floor type and spiral inclined floor type and other garage. 4.2.2 garage ramp type, in addition to the spiral ramp type, shall make its ramp system on each floor of traffic road unimpeded, formation, downward continuous pathway, and should prevent upper and lower road crossing. 4.2.3 the cold area should not be used in a straight slope car garage. 4.2.4 split-level car rolls straight ramp between floor is divided into two segments, the horizontal distance between two segments should make cars in the parking for 180 ° steering, the distance between the center line of the two ramps should not less than 14 m. 4.2.5 the three-segment fault layer garage must limit the driving route of the vehicle. 4.2.6 the floor space can be folded in the floor space, but the size should not be greater than 1.5m. 4.2.7 line double garage upward spiral ramp type should be used in outer ring left run anti-clockwise, the downside should use inner ring, outer ring radius and width can be calculated at this specification article 4.1.10 values increase appropriately, one end of the ramp should be set in building main body or irregular protruding parts of the plane. 4.2.8 when jumping the spiral ramp type garage, the floor shall be imported and exported directly, and its slope should be close to the center of the building plane. 4.2.9 floor slabs should not be more than 5 %. 4.2.10 inclined floor type parking garage with inclined column type, its long parking Spaces to the center line and the Angle between the fore-and-aft Central Line of oblique slab should not be less than