SCU-20驱动程序安装手册.pdf

SCU-20 PC Connection Cable Driver Installation Manual Installing the SCU-20 PC Connection Cable driver software on a computer makes possible data transmission and updating the transceiver firmware. Please read this entire manual carefully. If you agree to the content of this manual, download and install the SCU-20 PC Connection Cable driver. Operating Environment Supported Operating Systems ® ® Microsoft Windows 8 ・ ® ® Microsoft Windows 7 (Service Pack 1 or later) ・ Microsoft® Windows Vista® (Service Pack 2 or later) ・ ® ® Microsoft Windows XP (Service Pack 3 or later) ・ Installing the SCU-20 Driver Caution: Do not connect the transceiver to the computer via the SCU-20 PC Connection Cable until the driver installation process has been completed. Connecting the SCU-20 to the computer before installation has been completed may result in the wrong driver being installed, preventing proper operation. Install the driver, which matches to the operating system in use. Windows® 8 2 Windows® 7 4 Windows Vista® 6 Windows® XP 8 - 1 - Driver installation (For WinDoWs® 8) Before installing the driver, make sure that the SCU-20 PC Connection Cable is disconnected from the computer. Installation 8. Connect the SCU-20 PC Connection Ca- 1. Start up the computer as an “Administrator” ble to the USB jack on the computer. The user. SCU-20 PC Connection Cable will be rec- 2. Double check and ensure the SCU-20 PC ognized automatically. Connection Cable is not connected to the computer. 3. Unzip the downloa