POP-AIP期刊模板-2015.docx

Sample manuscript for Physics of PlasmasA. Author,1,2,a) B. Author,2,b,c) and C. Author3,c)1Department, University, City, Postal code, Country2Corporation or Laboratory, Street address, Postal code, City, Country3Department, University, City, State (spell out full name), Zip code, USAThis is an abstract. It gives the reader an overview of the manuscript. Abstracts are required for all manuscripts. The Abstract should be self-contained (contain no footnotes or citations to references). It should be adequate as an index (giving all subjects, major and minor, about which new information is given), and as a summary (giving the conclusions and all results of general interest in the article). It should be approximately 250 words. The abstract should be written as one paragraph and should not contain displayed mathematical equations or tabular material. In this sample article we provide instructions on how to prepare and submit your papertoPhysics of Plasmas, a journal published by AIP Publishing LLC. The AIP Publishing staff appreciates your effort to follow our style when preparing your manuscript.I. INTRODUCTION: THE MANUSCRIPTPlease use this “sample manuscript” as a guide for preparing your article. This will ensure that your submission will be in the required format for Peer Review. Please read all of the following manuscript preparation instructions carefully and in their entirety. The manuscript must be in good scientific American English; this is the authors responsibility. All files will be submitted through our online electronic submission system at.Manuscript preparationArticles canbe prepared as either a Microsoft Word .doc/.docx file or a REVTeX/LaTeX file. The entire manuscript, should be set up for 21.6 × 28 cm (8-1/2 × 11 in. or A4) pages with 2.54 cm (1 in.) margins all the way around. The font and the point size will be reset according to the journal’s specs, but authors most commonly use the Times Roman font and point size 12. The manuscript beg