单剪螺栓连接复合材料叠层板螺栓孔周边应力场分布.pdfVIP

DOI :10.16579/j.issn.1001.9669.2006.02.023 Journal of Mechanical Strength 2006, 28(2):271～ 275 ○○ STRESS DISTRIBUTION AROUND THE BOLTHOLE IN THE BOLT-LOADED LAMINATE 　 (西北工业大学 力学与土木建筑学院, 西安710072) JIANG YunPeng 　YUE ZhuFeng (Department of Engineering Mechanics, NorthwesternPolytechnic University, Xi′an 710072, China) 　, —、。 , 。 —, , , , , , ;—。 , ; 。 　　　　 　V232.7　V214.32　V25 Abstract　Based on the three-dimensional model, the effects of bolt-hole clearance and friction coefficient on the stress field around the bolt hole in the bolt-loaded laminate has been studied.The research results showed that the maximum radial stress and the maximum tangential stress occur in the positionwhere the angle is consistent with the lay-up of the local ply.o the fiber longitude direc- tion coincides with the main load direction in every ply.The bolt-hole clearance affects the stress distribution around the bolthole greatly, and the radial stress distribution resembles each other for different bolt-hole clearance level.With the clearance increasing, the radial stress level increases;the maximum tangential stress decreases in some extent.ince the clearance exists, the radial stress distribution changes, the position of the maximum radial stress moves to the net bear direction.The friction coefficient in the contact area affects the stress distribution around the bolthole.With the friction coefficient increasing, the maximum radial stress decreases;and so isthe maxi- mum tangential stress. Key words　Laminate;Boltjoint;inite element method;Stress field