无心磨床加工的磨削缺分析（Analysis of grinding loss in centerless grinding machine）.doc

下载文档 降价啦

4
0
约7.24千字
约 6页
2017-08-15 发布于河南
举报
版权申诉
保障服务

无心磨床加工的磨削缺分析（Analysis of grinding loss in centerless grinding machine）.doc

1、本文档共6页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

无心磨床加工的磨削缺分析（Analysis of grinding loss in centerless grinding machine）

无心磨床加工的磨削缺分析（Analysis of grinding loss in centerless grinding machine） 1. spiral grinding surface. _) u PQ; `0 `3 V\G! A workpiece that is rotated and forms a spiral cut through the grinding area. There are five reasons: (1) the outer end of the grinding wheel is convex. The elimination method is that when the grinding wheel is trimmed, this outer convex should be trimmed a little more. (2) the pallet has crashed to produce sharp edges or is not only a rough surface. The way to remove it is by grinding the pallet or replacing the pallet. (3) the export of the workpiece and the improper speed of feeding. At this time, the speed of the export and the feed roller should be adjusted properly so that the workpiece can be fed and exported, and the speed and the grinding area will be consistent. (4) the uneven hardness of the grinding wheel leads to uneven threshing of the grinding wheel. A new grinding wheel must be replaced at this time. (5) the relative position of the axes of the grinding wheel and the guide wheel is biased. Must be re - searched as required. S\ p/ ~7 _g/ R3 Y 2. surface vibration lines; N5, L; O) W% n The vibration of the machine tool or the vibration of the workpiece during the grinding process results in the vibration of the surface of the workpiece. There are seven reasons: (1) the grinding wheel or other parts are unbalanced, and the clamping of the grinding wheel is not correct, so that the machine vibrates when the wheel rotates. At this point, the grinding wheel and the pinch plate shall be re balanced. The correct grinding wheel clamping method shall be used when the grinding wheel is installed. (2) the vibration of other machine tools or vehicles shall be transmitted to the machine tools. At this time, the machine tools shall be kept away from these vibration sources or dug into the anti vibration ditch to isolate and weaken the incoming vibrations. (3) the center of the workpiece is too high, the grinding wheel presses the workpiece to the s