液压故障（Hydraulic failure）.docVIP

液压故障（Hydraulic failure） I. Analysis and troubleshooting of common faults in hydraulic pumps Fault phenomenon fault analysis Removal method No oil or oil transportation Not in quantity or in pressure 1 、 the motor does not turn right 2 、 oil suction pipe or filter block 3, axial or radial clearance is too large. C; J: / E9) _? X0 U K3 {f- O 4 、 leak at the junction and air 5, too large viscosity of liquid oil or liquid temperature rise too high 1, check the motor to L x9 F5 `% x* P M4. 2. Dredge the pipe, clean the filter, replace the new oil, the J:, I, C., P5, P,! T! 3. Check replacement parts 4, S0, Q5, T:, ~2, T7, G 4 tighten the screws at each connection to avoid leakage Anti air mixing 5, the correct selection of oil, control temperature rise The noise serious pressure fluctuation of 5 s/ x/ S4 L+.]# C2 a | 1 、 oil suction pipe and filter blocked or filter capacity is small 3, Q#, a, x:, H#, R3, W, k#) f U 2 、 oil suction pipe seal leaks or bubbles in the oil 3, pump and couplings are not concentric, ]9 G7 D4 Y F RN 4 、 low oil level 5, low oil temperature or high viscosity, $u, {6, M, A; D; \ D/ K (] 6, pump bearing damage) N2, r+, Z (z#, h, x, R0, B0, X., P, V) 1, to clean the filter suction tube unobstructed, correct selection of 0 R5 |3 $\ * N? Filter 2, in the connection part or seal place add oil, such as noise (B$TV4 N4 s C5 G% Reduce the sound, tighten the connector or replace the sealing ring; the oil return should be below the oil level, and the suction pipe to a certain distance 3, adjust the H7 G* B x/) concentric: V! S4 O3 E9 L+ x |. 4, refueling fluid, n/, B#, s*, A9 ~) l, F7 ~ qD 5. Heat the oil to the right temperature 6, check (hand touch) pump bearing part temperature rise Oil pump shaft seal (H6 V - F5 S! The hydraulic resistance of the pipeline is large, so that the pressure in the pump is raised to the allowable value of the oil seal Check whether the oil drain on the pump body of the plunger pump is connected to the tank directly with a se