螺杆机维修（Screw machine maintenance）.docVIP

螺杆机维修（Screw machine maintenance） Screw machine maintenance: Product characteristics: The necessity of the overhaul of the main engine of the air compressor and the operation of the screw type air compressor when the main engine is running, the screw and screw, the screw and the main shell and the front and back are not in contact with each other theoretically, for three reasons: The oil film formed on a host of normal operation between the screw and the screw is not in direct contact, short time course in the host start or stop in the oil film or film has not yet formed a poor state, there will be some direct contact between the screw and the screw; The machining accuracy of the screw and the host casing to ensure proper clearance between the host and the host shell screw assembly, the clearance has been considered to host high temperature operation of screw and shell deformation difference problem; The clearance screw and the front end and the back end is ensured according to the technical parameters in the screw assembly, the clearance also has considered the high temperature operation before and after the screw end distortion difference problem, at the same time the compression screw radial load and axial load borne by the bearing at both ends of the positioning host, no axial screw the displacement, therefore further ensure the end clearance. With the running time of the air compressor by host bearing will inevitably be worn, which leads to the screw axial movement and produce radial motion increases, the change will make the clearance between the screw and screw and screw and the frame and front and rear face changes. The gap change is normal and permissible during the bearing life period, and the resulting gas compressor attenuation and the transmission motor load increase are normal and permissible. However, when the bearing wear and the clearance of the main engine clearance exceed the allowable limit, serious consequences may occur. First of all, the fricti