nec系统设置（NEC system settings）.doc

nec系统设置（NEC system settings） NEC common settings Ps: enter programming: SPK -- HOLD - #*#* - PROGRAM MODE (programming mode) Exit programming mode: press DC until PROGRAM MODE = SPK = save and exit programming Programming instruction: item LND to move the cursor cursor left HOLD to save DC, FLASH, back in the project programming project between OPAC and VOL to move the cursor right within the same project data (such as 1, 2 flip relay --, extension 200, 201 -- etc.) this operation will automatically save already change data CONF to left, delete key, CLEAR, right enter, delete key TOPAZ machine special phone prompts: check SW setting - cold, switch the machine left to right English explanation TRUNK - relay line, outside line priority, priority KTS, digital telephone GROUP, group number, member SLT, ordinary telephone DSS thcomng direct access to Taiwan, outgoing to enter First, the time setting 10-01-01 00-99 has no input two digit number: 00-99 10-01-02 month 01-12 has no input two digit: month (01-12) 10-01-03 no set two digit digits: 01-31 (01-31) 10-01-04 week 1-7 is not set. Enter two digits: Week (Sun-Sat) (1 = Sunday),...... ... 7 = Saturday) 10-01-05 hours, 00-23 is not set, enter two digits: 00-23 10-01-06 point 00-59, no input two digit: 00-59 10-01-07 seconds, 00-59 is not set, enter two digits: 00-59 Two, caller ID 1, 14-02-10=1 open caller ID for each external line 14-02-16 0=FSK 1=DTMF external format 15-03-09=1 opens the caller ID for each common extension (each extension should be set up) 15-03-14=1 does the ordinary extension to the general extension show an outside number (default is 1)? X affects the callers availability: the machine may not be connected to the ground 2, change the incoming ringing mode 20-15-01 sets the ringing mode for trunk calls 20-15-03 sets the ringing mode for incoming calls Three, system number change 1, change out number: 11-01-01 11-09-01 The extension number can be changed at will. The default extension number