手动张力控制器（Manual tension controller）.doc

手动张力控制器（Manual tension controller） Manual tension controller In the industrial sector, in some ribbon and linear products, often need to control the tension to achieve the production requirements, a tension controller is to control the instrument this kind of tension, tension controller is an embedded device or system is composed of MCU and peripheral circuit is developed, is a kind of control instrument, which can be directly set requirements for the control of the tension value, then the direct input signal of tension sensor (usually millivolt level) as the tension feedback value, by comparing the deviation, input processing to PID controller, the best output to the peripheral actuator to control, and ultimately achieve the smallest deviation, the fastest response to system. The tension controller and so-called manual control function, generally refers to human can given a certain amount of tension controller output to the actuator (often current motor); some tension controller with coil diameter calculation, generally used in coiling equipment, have the unrolling and rolling of taper; in addition in the internal controller adjustment function, can directly set some requirements on the process of coiling taper. The tension controller adopts the international advanced technology; special microprocessor, 18 bits high speed A/D converter, switching power supply, automatic recovery and anti-interference technology, PID nonovershooting algorithm, KTC2808-v1.0 tension controller is all digital design, so it has high control accuracy, strong anti-jamming, complete function, simple operation etc.. 1 all digital design, adjustable potentiometer, tension calibration process is simple, accurate tension measurement, stable and reliable. The measurement accuracy is up to 0.2. 2 to adapt to all kinds of tension sensor is used as the input signal; (1) can be used for the micro displacement of the tension detector (input signal range of 200mV, the power supply for 15V (2)) can ch