500程控（500 program）.docVIP

500程控（500 program） Err1: the fluctuation range of the power supply exceeds the prescribed (more than 10%) 1, the external power supply voltage fluctuation range is more than 10%. Resolvent： Please users with the local power supply units (such as power supply bureau) for help. The user to purchase investment if the external power supply regulator, although fluctuation range of more than 10%, but relatively stable, can purchase sufficient capacity regulator. In the use of voltage regulator, voltage regulator must be installed in the exposure process adjustment locking circuit, otherwise it will cause damage to the console and the regulator. 2, the power supply board (1 boards), power sampling value range (DC11V~DC9V) Solution: if not meet in DC 11V~9V, power supply board internal resistance value detection between R1 and R2 through the potentiometer voltage adjusting potentiometer R2 to meet the: V=V /380 * 10 (V for the current measured voltage) 3, the power supply board (1 boards) in the power supply sampling point (position between R1 and R2) before the circuit fault Solution: check the resistance of R1 and R2 before the potentiometer circuit components, for example, transformer T1, silicon bridge V1, F1, V2 and other insurance tube diode. For the replacement of damaged components. 4, the power supply board (1 boards) in +15V power failure Solution: check the power supply board test voltage is normal (TP10 + 15V + 0.2V~ + 0.1V). When the voltage is too low, may be the machine internal short circuit, or LM338 (LM7815) damage, repair or replace. 5, the power supply board (1 boards) in D1, D2, V7 devices and V8 anomaly Solution: the working voltage of D1, D2, V7, check V8, judge device abnormal, for replacement. 6, the power supply board (1 boards) and computer board (8 boards) between the interface part of abnormal operation Resolvent： To check the power supply board (1 boards) and computer board (8 boards) between the connector is reliable contact, to repair the unr