cad尺寸标注命令（CAD size marking command）.docVIP

cad尺寸标注命令（CAD size marking command） Dimension command 2009-10-15 11:31:00| classification: blue | Tags: | name and subscription. First, new text styles 1. call (1) command line: STYLE (2) menu: format to text style After using either of these methods, display the text style dialog as shown Click the new button to display the new text style dialog box as shown in the figure below, and click the OK button to create a new text style name. Two, set the font name and height (1) in the font name list, select the font name and determine the font height (if you write a single line of text, you can enter the word height in the command window), the user can also choose font effect as needed (2) click the apply button, click the close button (recommended TT font font design Chinese characters GB2312) Three, special characters When writing characters in graphics, in addition to Chinese characters, English characters, numbers and common symbols,.AutoAD2004 also provides control codes and some special characters. Such as the diameter of a circle, symbols, degrees, symbols, positive and negative tolerances, symbols, etc.. These symbols cannot be transferred directly from the keyboard. Use the control code setting. The definition of the control code is shown in the table. Four, multi line text tagging and editing There are two ways to input text: one is to use Text and Dtext commands to enter a single line of text into a diagram, and the other is to enter multiple lines into a diagram using the Mtext command (that is, multiline text editors). The operation method of two kinds of command and the Mtext command will be similar to the text as an object, especially suitable for processing the paragraphs, its function is far than the Text and Dtext commands more powerful and flexible, therefore, here only introduce multiple lines of text input. 1, start the command: (1) command Mtext 2) drawing menu, in the drawing menu, select the multiline text command of the text submenu. Toolbar, cli