在3d建模过程中要注意以下几点.docVIP

在3d建模过程中要注意以下几点 In the 3D modeling process should pay attention to the following points: Do the following work in the Projectname_master.prt file: the appearance size, parting line and parting datum, draft angle Draft angle, smooth transition fillet (referring to the appearance about big rounded); All Part public Curve also depends on the skeleton model: such as keyboard hole, Ce Jiankong, hole, horn antenna sound hole, Receiver sound hole, hole MIC, cell boundary, contour line, the button battery plug contour; In the Projectname_master.prt file, in surface and surface in combination with the local try not to fillet, because the fillet in regeneration process of Pro/E, it is easy to make mistakes; sometimes on the shell structure design behind the problem (Shell). For the point, line and surface: try to use simple Curve such as straight line: simple circular complex arc polyline complex point or surface; It is best not to directly generate in the general assembly (Creat) single Part, single Part should be created separately: this can have Right, Front, Top datum alone, rather than the name Datum1 and Datum2 benchmark. So we in the modeling and structure design of the follow-up process, try to use these original datum as a reference; The draft as far as possible the use of scanning Sweep into the system, so that it is easy to modify; If the mobile phone appearance has changed, can be modified directly in the Projectname_master.prt file, and then re generated (Regenerate).Prt on the line. When a component.Prt to be moved to the other folder in a folder, must use Back up, or Projectname_master.prt file will not move, so the.Prt file cannot be reborn; In the initial stage of modeling, the general can not be all related to other parts of the common features are expressed in the Projectname_master.prt file (especially Keypad Curve line), is actually never mind, still can continue. Because in the process of modeling can continue to add features in the master file, as l