常见针织物疵病和机械故障的产生原因（Causes of common defects of knitted fabric and mechanical faults）.docVIP

常见针织物疵病和机械故障的产生原因（Causes of common defects of knitted fabric and mechanical faults） 指针是否轧刹 弯纱三角吃线快慢不一致－－－－－－修磨校正 弯纱三角下边压针面太阔平坦－－－－适当磨窄磨坦、磨 针床栅状齿锋利不光滑－－－－－－－磨滑抛光 喂纱嘴过低－－－－－－－－－－－－调整更换 喂纱嘴口破裂－－－－－－－－－－－调整更换 张力弹簧太硬－－－－－－－－－－－调整张力弹簧 针舌面破损－－－－－－－－－－－－更换新针 针舌销子露面－－－－－－－－－－－更换新针 针舌闭进针钩内－－－－－－－－－－更换新针 毛纱强度不够－－－－－－－－－－－更换毛纱或过腊 毛纱支数太粗－－－－－－－－－－－应换成与 The machine adapts to the wool yarn joint too big - - - - - - the knot hanging snake is too heavy - - - - - - - - - adjustment A: 3, in the process of weaving. Needle heel and each Braided River Delta needles are impingement and mechanical failure caused by the firing pin, including needle heel silent broken (playing stuffy needle), nose needle climbing, tongue injections. It damaged needle, needle and triangle itself, and even affect the quality of the fabric. The causes of failure and the methods of elimination are shown in table 3. 表3 －－产生原因－－－－－－－－－－－－－－排除方法 各成圈三角起痕重或破裂－－－－－－－－－磨光砂滑或配换 各成圈三角间离缝太大－－－－－－－－－－调整各成圈三角位置或配换 弯纱三角针道太阔－－－－－－－－－－－－配换 弯纱三角下边压针太尖－－－－－－－－－－适当磨大 起针三角走针面大于直角－－－－－－－－－修磨 起针三角上角太低（与顶针三角不平）－－－填平 起针三角断裂－－－－－－－－－－－－－－修磨或配换 起针三角直柱螺栓松动－－－－－－－－－－旋紧螺栓 成圈三角离针床的间隙过大－－－－－－－－垫三角 In the circle triangle heat treatment hardness is not enough - - - - - - - to be re heat treatment or change the thimble triangle and the needle triangle seam or hair - adjustment, polished thimble triangle narrow needle triangle wide - - grinding needle triangle. Change the top needle guide triangle triangle to triangle short thimble - - - - - change oriented triangular needle groove is too wide or needle groove convex - - the maintenance of needle bed needle groove needle hardness is not enough - - - - - - - - - replacement needle heel capillary bending - - - - - - - - - - - to replace the needle holder with the needle surface - - - - - - - - replace and remove fouling needle groove 4, edge exclusion (broken edge, rotten side): fabric selvage produced raveling coil caused by the sample edge is not smooth, called edge exclusion. The causes and me